"We purchased our Ercolina Top Bender back in the early 90's and when it came time to upgrade we didn't think twice about buying a new Ercolina Mega Bender. I could never imagine going back to using elbows, with all the welding, grinding and labor involved."

Bob Cavanagh, Mid Island Steel

"The machines are a very solid product. We used the first bender so much we got another one a couple years later and use them both daily. The roller we have works very well for us on many jobs and is used every few months as the specific jobs dictate. It is nice to know that we have dependable machines to get the jobs out the door in a timely manner. Production time has reduced and that helps the bottom line.

Good People
Good Machines
Reasonable price, would buy again, thanks Dave."

Richard Fox, Vice President/Shop Supervisor, RAMCO

Rotary Draw Accessories

Profile Folding/Bending Attachment
Tight radius solid profile bending attachment.
Fits 030, TB60, SB48 and 060 machines
Part# 051

Bending Capacities
Material Type	Maximum Diameter
Round solids	.625
Rectangular solids	.187 x 4.000
Solid square	.625 x .625
Angle Iron	2 x .312

Counterbending Die Supports

Counterbending Die Supports
Counterbending die support bracket required
when bending radii 225mm and larger.
Part# 050E

Roller Counterbending Dies

Roller Counterbending Dies
Available for round and square profiles,
roller dies are recommended when bending high tensile materials, solids, heavy wall profiles and rusted material.
Note: Roller dies must be positioned a
minimum of 2½″ from face of centerformer,
failure to do so will cause machine damage. Depending on application 180 degree bends
may not be achievable.
Part# 050I for ⅜″ to 2½″
Part# 050J for 2½″ to 3″

Rotary Draw Tie Bar Accessory

For use on Megabender 030, TB76, TB60, 050KD, SB48, and 060 Superbender. Tie bar accessory should always be used when bending heavy wall profiles and solid materials.
Part# 030TIEBAR

Bending Lubricant

To maintain quality bends counterbending dies should be replaced when face of the die touches center former. Tool life will vary depending on material to be bent. Standard brass dies are designed to be compatible with most materials. Replacement dies are also available in steel and polymer. Consult CML USA for application information

Recommended for non-mandrel, mandrel and roll bending applications.

Ercolina’s^® lubricant improves bend
quality, reduces material drag while
extending tooling life.

Part#	Description
810	One (1)12 ounce can
811	Nine (9)12 ounce cans

Mandrel Lubricant

Part#	Description
812	One (1) pint

Mechanical Tube & Pipe Positioner

Mechanical Tube & Pipe Positioner

Adapts to Ercolina tooling for quick and accurate material positioning. For use with all Ercolina rotary draw machines.
Part# 050M

Content on this page requires a newer version of Adobe Flash Player.

Rotary Draw Accessories